MadRadioModder, that would be too easy.? I am not an electronics expert, only a builder and tinkerer.? I will learn more from modding the V3 than I will ever learn from assembling the V5.? Just my thing, I guess.? I just enjoy the build.? Funny comment, though.? Dale
An easier fix is to sell the V3 and buy a V5.? Boom.? Done.
?
?
From: [email protected] [mailto:[email protected]] On Behalf Of Dale Hardin
Sent: Saturday, September 21, 2019 5:10 PM
To: [email protected]
Subject: Re: [BITX20] WTB 680nF Inductors #parts
?
I think the whole smd inductor - alternate relay thing has been discussed?to death.? Seems there are two options, inductor-relay fix or off-board relay fix.? I can do the inductor-relay fix without cutting and pasting a new board in (sorry Gordon Gibby).? If that doesn't do the job on my board, then I will spring for the off-board relays.? I do want to use the very same inductors that work, but I don't want to buy 100 of them, hence my request.? I'm sure there are thousands available here on the group.? You didn't say what solution you found to the spurs issue.? Did you go the off-board relay way?? Thanks for your comment. Dale
?
On Sat, Sep 21, 2019 at 4:07 PM Jonas Sanamon <sanamon@...> wrote:
Hi Dale,
Not to discourage?You from doing this,? but my experience with replacing?the toroids with the 680nF SMDs showed no change whatsoever. I have photos of the spectrum analyser screens before and after and they are pretty much identical.? But maybe this is because i haven't done the relay replacement modification yet...?
?
Anyone have surplus 680nF inductors for V3 fix of spurious signals?? If so, contact me privately to discuss details.
Thanks, Dale
--
Dale Hardin, KS4NS
Elberta, AL
--
Dale Hardin
Elberta, AL 36530
251-597-9256
--
Dale Hardin, KS4NS
Elberta, AL
--
¡_. _._
--
Dale Hardin
24750 State St. Unit 487
Elberta, AL 36530
251-597-9256
--
Dale Hardin, KS4NS
Elberta, AL
Dale Hardin KS4NS