Evan,
The missing transistors are for alternate use of RDD series. You remove the IRFs and replace with RDD16.
RDD pin outs are different so you have been provided alternate holes on PCB.
The missing caps places are there if you want to put them in to compensate for flattening the power. Options only!
Raj
toggle quoted message
Show quoted text
At 23-02-19, you wrote:
Not sure who is the correct person to send this to in a private email, so created a new thread for all to see.
When I first started on the ubitx journey, I was often confused by the differences between what was on the published schematic and what was actually provide. Currently there are 2 that I am aware of:
1 - Q942 and Q952 do not exsist, and I am not sure would work as shown (most times you need some sort of resistor or other feedback to keep 2 parallel active devices sharing the load). Regardless, they are not there
2 - C210 and C216 also do not exist (though at least they do have a 0 as the value}.
I know that these are minor points, however there is enough things to learn without having to verify that the schematic is in fact what is on the board.
This should not take that much effort, as it is just removing the components from the original and saving a new PDF.
The above are my opinions only
73
Evan
AC9TU
Raj vu2zap