Just finished putting the BITx40 in an enclosure and most things are working.? I set it up first in the default configuration and tested per directions.? I then installed sketch v.1.28 per instructions and all seemed well. Next I did all the modifications for raduino-v1.28 except the capacitance touch sensor.??
?
One issue is that when I make changes in the Settings and set up the rig for cw operation, when I shut down the rig, I lose all the previous settings for cw and only lsb or usb is available.? When I turn on again the VFO may show the mode as CWU/L but no keyer or ptt and when I go to Settings no CW options.? I am not able to send cw and cw is not shown as one of the modes available when go to Select Mode.? If I do a default reset and then set up cw it works until I shut it down.? Then I lose the settings. Must be missing something.? I downloaded v1.28 again and reinstalled it. No luck.
?
Another issue I have is that the CW Spot does not work.? I have installed a momentary push switch, but it appears to not be grounding the pin.
I am impressed with the rig and it works perfectly when set up either for ssb or cw with the above exceptions.? Only when I shut down, I lose the settings.
?
Thanks for any help.
Gary K4VIG
?
