On Sun, 26 Aug 2018 08:53:06 -0700
"Eddie Esserman" <ee@...> wrote:
Hi Eddie, are you using the KD8CEC sketch?
The default sketch dosn't have those advanced
ADC settings.
If you are using the default sketch, and the resistors and
voltages are right, then you are stuck.
/g/BITX20/topic/ubitx_keyer/7491087?p=,,,20,0,0,0::recentpostdate%2Fsticky,,,20,2,0,7491087
As the main man says, its all in the software.
If you are using the CEC sketch:
I havn't done this personally myself, as I said I use
an external keyer for the paddle.
But........
You probably need to play with it a bit to get the hang
of how the tuner switch changes mode.
You probably need to be very careful recognizing which
mode you are in, and which sub setting you have on display.
Follow the above link. Sometimes you press the tuning key
and in some menus you need to rotate it to the desired
selection, then press again to change value.
Sorry, thats the best advice I have right now.
Good Luck, and be calm and deliberate with
your actions with the tuning switch.
Read the manual, there are 3 different pushes too.
A quick push, a longer push, and a 2 second push.
Each one will take you somewhere different. :-)
It says the Memory Manager has a setting
for the A6 ADC level. It's called the 'dot range'.
Joe
KN4OND
Joe
Thanks, Joe,
How do you (or I actually) get to the iambic a and b page?? That's where I think the block may be.
Straight key is working, and so is the dot side of the keyer. No dashes, paddle and resistor are good.
Eddie
WA4JXL
