Hi folks ¡ I noted the same issue on my AGC board ¡ and then I looked at the pads on the bottom. ?Of course the square pads (indicating the indexed pad ... ? [ ] ? 0 ?... ) were easily seen and when I took them to be the non-ground pad, everything fell into place. ?I suspected that the ¡°5v¡± legend was simply to identify the connection pair for power and ground ¡ there was no room on the board to put it on the other end of the connection pair.
So ¡.. after discovering the index pin, everything got hooked up just fine. ?:-)
Thanks again Kees!
Bob Harbrecht
KE7QEQ
On Jun 21, 2018, at 10:13 PM, Glenn <
glennp@...> wrote:
Kees,
I think there is an error on the AGC pcb overlay. The hole marked as "5v" is actually ground. The hole adjacent is 5v.
glenn vk3pe
<KEE_S AGC PCB 5V _ GND REVERSED.JPG>On Thu, Jun 21, 2018 at 05:14 pm, Kees T wrote:
I have updated the AGC/Click mini-kit "ordered/shipped" list in the "Files" section per today's information. There will be some delay before more kits can be shipped because I'm out of AGC boards and have just ordered another 160. I have plenty of parts.
73 Kees K5BCQ
ENGINEER ¡ Solving problems you didn¡¯t know you had in ways you can¡¯t understand. ? SigCat
