Yes, the firmware I have in use is UBITX_CEC_V1.080_16P.hex - the standard display.
I did activate the S-Meter in the Memory Manager (I am using uBITX_MM_V1.081 here).
I have attached my configuration file. Maybe there is something what I am just overlooking.
The values which have added for S-Meter steps are fictional - i wanted to do the calibration later with my lab equipment.
But I can read out the ADC values of A7 and I get always changing values between 30 and 190 if i tune to an AM Broadcasting station.
As these values are withink the steps I defined, i think something should be shown. Or could it be that the values are changing too fast?
I have also attached a picture of the wiring of my ND6T AGC_KIT Wiring. I think I connected it properly but maybe I am wrong.
However I think the mistake is somewhere within the software. Instead of the S-Meter in the right corner ?
I just get shown "ST" which i think is short for "XXX Hz Tuning STEP", right?
And somewhere my Callsign should also scroll within the screen with these configuration, or am I wrong?
