On Sun, Jun 17, 2018 at 10:16 am, AG?H wrote:
Also, I had read in one of the posts that re-flashing the Arduino with Ver 1.27 does NOT re-set the original values .? Is that right??
No, all settings will be reset to "factory" values after each version upgrade.
If so, how can I clear out the bad settings?
Power on the radio while keeping the Function Button pressed. This will reset all settings to "factory" values.
However I doubt that this will fix the problem.
The problem as you describe it, is more likely caused by noise, incorrect wiring, poor grounding or a bad power supply.
73 Allard PE1NWL
Allard PE1NWL