Re: uBitx first power on - issues
|
Well had a actually followed the directions, and not had the raduino plugged in, everything would have been just fine.? I'm reading 0.091a, which is what the directions said I should be reading.??
THANK YOU!!!!!!
--Jim
That is probably it if the Radino is plugged into the main
board?as the "key" logic circuit will float and cause the transmitter to be
keyed, off and on without the resistor.? If that solves your problem you
are not the first nor the last to have it happen to.? Many uBitz owners
over the last few months have had the issue and complaint. There was a?lot
of message traffic in the beginning regarding this.?
?
Rick
?
?
Thank you for the quick response Rick!? So, you really think
that's it huh?? And what you're saying is the wire-up directions should be
modified to include this caveat.
Thank you again!
--Jim <insert call sign I don't have memorized yet.. and I'm an extra
w/out having ever made a contact>
?
Make sure you have the 4.7K resistor installed in the keyer
circuit per the wiring diagram attached
?
Rick KN4AIE
|
