On Wed, May 23, 2018, 2:45 PM Sam Tedesco <stedesco619@...> wrote:
Thank you! I thought about that. I tried reverting to the original firmware and it was the same. Was tempted to disconnect the entire encoder but left it as is. Will give it a shot.?
On Wed, May 23, 2018, 2:34 PM John <vk2eta@...> wrote:
Hello Sam,
There is a good chance your Raduino is likely working and you have an issue with the encoder.
Since it displays the version at start and nothing more after that it certainly looks like you have the push-button locked or shorted in the down position.
In the factory firmware and the KD8CEC firmware (at least the version you are using), when the push-button is held down at start-up it first waits for the button to be released, then it enters Factory Alignment mode. That's why I suspect the push-button input is held down permanently.
Easy test is to just disconnect the brown wire from the Raduino connector and see if you get the frequency displayed.
