If you have zero volts on pin 6 then either your software is not
working correctly or the nano is not working correctly.
tim ab0wr
On Wed, 16 May 2018 16:32:19 -0700
"kj6etl" <pa1zz@...> wrote:
Hi,
I am strugling with a uBitx. The Raduino isn't responging to any
input.
There is 0 volt on pin 6 (red wire for the funktion button) to ground
on the yellow wire (pin 4) or common ground on the chassis.
I guess that without power we can't switch anyting. I tested with and
without the encoder connected etc etc.
Do I have a faulty arduino board or can this be fixed with software?
Looking forward to your replies.
Rogier
