Re: Removing solder resist.
|
?
If one of these brush pens doesn't do it, find out who the manufacturer is and let us know. The fiberglass brush is best for most resist coatings.
Sent from Yahoo Mail.
On Wednesday, May 9, 2018 1:38 PM, MAX <max@...> wrote:
Thank you.? Acetone sounds better than alcohol. ? Regards. ? Max K 4 O D S. ? I've Never Lost the Wonder. ? Antique Electronics Site: ? ?
? Well not all solder masks are created the same. That said acetone or toluene will work on some, water and orange oil in others. ?Some is polymer based and must be scraped off.? ? Dr.?William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton - J68HZ Soufriere, St. Lucia W.I. Rent it: ? ? On May 9, 2018, at 6:56 AM, MAX < max@...> wrote: Does anyone have a good trick for removing solder resist from a PC board? ?Scraping at it with an exacto knife seems a bit clumsy and I have never been able to leave a neat looking exposed copper area behind.
Regards.
Max K 4 O D S.
I've Never Lost the Wonder.
Antique Electronics Site:
|
