¿ªÔÆÌåÓý

  1. BITX20
  2. Messages
Single Messages Topics Expanded Polls

Re: uBitx 20 goes to Alignment on startup

 

Well, you are the only one that has ever reported this problem so I believe you have a bad Arduino NANO on your Raduino card, or your Nano's A2 input is shorted to ground. ?That's just about all that could cause this problem unless the software somehow got corrupted. ?Just in case that happened, please go to ?and click on the?"W0EB/W2CTX uBITX Files" link. ?That will take you to where you can download V2.02R again. (The other zip files there are for the I2C enabled displays and won't work on your uBITX) Try re-compiling V2.02R and re-loading it to your NANO. ?If that doesn't work, the only option is probably to replace the NANO. ?

I just recently created this website to make it easier to find our software releases and other stuff we're doing for the uBITX.

Jim, W0EB

------ Original Message ------
From: "Jim" <ei8igjim@...>
Sent: 5/4/2018 11:08:05 AM
Subject: Re: [BITX20] uBitx 20 goes to Alignment on startup

Thanks for the reply;

checked for shorts, found none...

does same with function button disconnected.

Jim ei8ig

On 04/05/2018 16:48, Jim Sheldon wrote:
Sounds like your encoder/function button is shorted or you have a Raduino Digital Plug pin 6 (red wire) shorted to ground. ?Either that or a shorted A2 analog input on your NANO.

W0EB

------ Original Message ------
From: "Jim" <ei8igjim@...>
Sent: 5/4/2018 10:43:22 AM
Subject: [BITX20] uBitx 20 goes to Alignment on startup

firmware : groups.io/g/BITX20/files/ubitx_V2_02.zip
uBitx 20 goes to Alignment on startup with no button press
can't reprogram arduino in Alignment mode
thanks Jim ei8ig

Join [email protected] to automatically receive all group messages.