¿ªÔÆÌåÓý

  1. BITX20
  2. Messages
Single Messages Topics Expanded Polls

Re: No PTT

Geoff Theasby
 

Hi Jerry & John,

Set up as before, reads "LSB A 7.150". No voltage detected at the pins in question. Checking with the ohmmeter (Raduino switched off) at the encoder shows continuity on-off-on-off as the knob is turned. Both pins similar, but out of phase of course.?
So, no volts from Raduino. (Display facing up, using the two pins at extreme right)

Regards
Geoff

On 26 April 2018 at 12:19, John <vk2eta@...> wrote:
Hello Geoff,

Yes Jerry's point is quite right. You will need to setup the Arduino development program in any case to reprogram the new Nano.

So you may as well do that now and load the diagnostic software to check if your Arduino is working as expected or not.

I will get that software ready tomorrow regardless, because I think it should be a tool available to the kit builders.

Let us know what you find in the mean time.

All the best,

73, John


Join [email protected] to automatically receive all group messages.