Jerry didn't write the check, but that's in the ballpark for a fully loaded license.
I was encouraging them to look at other tools like Eagle, and later Kicad.
I like cheap, and would also prefer to not use anything stuck with MsWindows.
But folks there have a history of using PadsPCB going back to the 1980's,
and inertia is one of the elemental properties of the universe.
Jerry
toggle quoted message
Show quoted text
On Thu, Mar 1, 2018 at 10:49 am, Michael Hagen wrote:
Jerry didn't not mention what the cost of Pads was, I bet over $10K.? And maybe another couple K PER YEAR to keep the license up.
?
