¿ªÔÆÌåÓý

  1. BITX20
  2. Messages
Single Messages Topics Expanded Polls

Re: Tell me your favorite uBitx mods

 

¿ªÔÆÌåÓý

I was an easy one to think of, I recently setup a Raspberry Pi with a TNCPi. ?The board has one connector and two adjustments that need access from above. ?I wanted my custom board to be the top most board so I made holes for the adjustments and connector. ?What¡¯s particularly screwy about this is if you want two TNCs you can install two board but they make no provision for adjusting the lower board.


Clark Martin
KK6ISP

On Jan 1, 2018, at 8:43 PM, Diver Martin <diver.martin@...> wrote:

Yaknow, I hadn't even thought about that... adding holes to the PCB for a screwdriver to pass through :)? Good catch clark!

On Mon, Jan 1, 2018 at 8:42 PM, Clark Martin <kk6isp@...> wrote:
As far as alignment is concerned, if the new board has holes over the locations of the Pots on the uBitX board then that at least can be done without service cables or board removal.
Join [email protected] to automatically receive all group messages.