My pleasure!? I remembered reading it but couldn't immediately find it when I 'needed' it.? (Story of my life.? LOL)?
Thanks for blazing this trail - I look forward to getting my rig on the air when it arrives.
(Why do I get the feeling that I'm going to end up with a couple of these radios?)
Happy New Year, Doc
Andy
toggle quoted message
Show quoted text
On Sun, Dec 31, 2017 at 03:38 am, Gordon Gibby wrote:
aha!!! ?yes, thank you, extremely helpful.
?
The factory alignment does essentially the same steps just slightly different ways.
?
?
Thank you for pointing that out, I hadn't seen it.
?
The way I selected the BFO frequency apparently is just a tad "bassy" for the preferences of the ALE algorithm. ?shifting it (from my pick)?to give another couple hundred hertz on the treble side would make the uBitx almost perfect for a ALE scanning.
?
One of the ALE expert's (looking at the schematic) pointed out my error: ?upon closer examination, the transmit relays are NOT clicking at all when one merely scans receiving frequencies; ?I was hearing small pops in the speaker and thinking those were relays clicking.
?
The uBitX ?is able to scan at full speed, (selection: five frequencies per second), continuously, without the need for any relay ?actuation. ? Makes it almost a perfect receiver for ALE or similar scanning.
Sent from my iPhone
On Sat, Dec 30, 2017 at 12:01 pm, Gordon Gibby wrote:
?
?(A "manual" for factory alignment would be wonderful....)? ?
Useful???
