On Wed, Dec 20, 2017 at 04:48 am, Vince Vielhaber wrote:
Ok, replying to myself here. Like I said, I'm not convinced there's
anything wrong with the Si5351.
Is the raduino mounted in the case or is it out by itself? If it's
installed, remove it so we can eliminate the other variables.
It is hanging in the air about an inch above anything...supported only by the USB port. I do this with all my little boards if I can...make sure they can't get grounded in bad places.
1) double check that the 25MHz sketch from Gordon still works.
Yes...I did this AFTER I reported here. So, it worked the night before last, Farhan's sketch failed, Gordon's sketch failed, then I retried the 25Mhz sketch and it worked again. Note that I loaded and tried all these sketches one after another without physically touching the raduino. If it failed, I'd unplug the usb and plug it back in to restart the raduino, but I wouldn't touch the raduino itself...only the USB it was dangling from.
