This is on a BitxX40.
Vince.
toggle quoted message
Show quoted text
On 12/18/2017 03:16 PM, Jack Purdum via Groups.Io wrote:
I think grounding can be an issue if you're using a plastic case. The
?BITX expects all of the sockets to be at DC ground.
Jack, W8TEE
------------------------------------------------------------------------
*From:* Allard PE1NWL <pe1nwl@...>
*To:* [email protected]
*Sent:* Monday, December 18, 2017 3:02 PM
*Subject:* Re: [BITX20] Help! I think I may have just ruined my 9 year
old's Chanukah
Well I just tried it out, the radio first restores all factory settings,
then goes through the setup sequence and finally ends up in the SETTINGS
menu.
However, when there are grounding issues then there might be noise on
the Arduino input pin (the arduino might sometimes see a 'LOW',
sometimes a 'HIGH') and then the behaviour might be different.
73 Allard PE1NWL
--
Michigan VHF Corp.
