A hole for a 4 pin mic in front removes the need for a 3.5mm mic connection on the front.
As a compromise, I could easily support a couple 'unassigned' 3.5mm jack holes in the back to allow for add-ons, hacks, they could also serve as ventilation if unused.
That raises the question of suitable ventilation for the chassis - passive will require a lot of holes, active (fan) might reduce that need... would the heat sink on the finals float or be bonded to the chassis?
Ken, N2VIP
toggle quoted message
Show quoted text
On Dec 13, 2017, at 11:58 AM, Rod Self <km6sn@...> wrote:
I fully support the request for a round 4 pin mic connector hole, front panel. There are so many 4pin mics out there. Additional 3.5mm mic hole, front panel sounds good, too.
Too many holes?
