Re: Two little circuit boards for my Bitx40 txcvrs
|
Looks like some research is required on such techniques.
M
On Wed, 22 Nov 2017 at 8:18 PM, William R Maxwell < wrmaxwell@...> wrote:
Any of the usual smd
desoldering techniques will do the job, Mike. Hot air source
or? solderwick with lots of flux etc.
Bill VK7MX
On 22/11/2017 5:21 PM, Mike Woods
wrote:
A week or two back somebody was commenting on a
chip that does voice compression.? A quick search on AliExpress
found a module that uses said chip for a few dollars, so I
bought a couple for my Bitx40s.
I figured these boards were a bit bigger!? The
coin is about the size of an American quarter.
Any ideas for how to remove the tiny resistors R1
and R2 (about 1mm in length and .5mm wide) so that I can use
potentiometers instead? ?
These modules are very tiny indeed!? There will be
no trouble finding room for them in any enclosure.? I will
report on how they work in a few days time!
|
