Re: Arduino USB cable extension ???
|
Sorry for my weak memory I actually installed a "down angle mini 5 pin USB to USB 2.0 B female panel mount" it is 50 cm long so you can mount it any where on the back of your BitX.
You could also use a "right" but if space is tight, the down takes up less space. 73 Willy??
On Wed, Nov 1, 2017 at 10:23 PM, Willy <W1LY@...> wrote: Besides left and right they are available in up and down. I installed an "up" because it was shorter than a left or right and I had very little space between the 10 turn pot and the USB plug. It just fit, where the left and right were too long. I do not remember what vendor? I used, just did a search on eBay. It only sticks out 9/16" or 14.3 mm from USB plug which was exactly the space I had. Needed to remove the 10 turn pot to install it but that was better than having to drill new holes? or remove the pot for each new sketch. Hope this helps, Willy W1LY
|
Willy