check the condition of the Fun switch.? Check the switch is actually "normally open" re check for resistance in the open state.? Or replace the switch.??
?Re-seat the LCD
Check where the connection is soldered in at the DDS for solder bridges. (ground)
Check the DDS PCB component/wafer connections solder junctions.
Maybe check for stray wire on the Tune pot shorting or cat "whiskering"....replace the pot with the kit supplied tune pot.?
I've had the blue 10k 10T pot go out already open internally. Early indication is the pot turns roughly towards the end of life.
I have installed amunters code on my newly built Bitx40 and the first thing I wanted to try was to swap out the one-turn 10k pot for a 10-turn 10k pot and to install the function button. The pot itself seems to work properly however when I press the function button I get garbage characters on the screen. I can make out some characters and words but it's mostly unreadable. Has anyone else seen this? I've tried searching through the forum but I can't find anyone else with this issue.
