开云体育

I received a 10 turn pot today, installed and changed the sketch for a 300 kHz span. It works great, however I found the tuning a bit too coarse. I changed the span to 100 khz, tuning was much better, but unfortunately, on my pot, it appears that there is just enough resistance left at the upper end? (300 hz) to keep the vfo from jumping to the next 100 hz step. Where in the sketch can I change the tuning value to address this?

Also, for all you other newbies...don't do what I did and forget? to hold the function button while powering up the radio after loading the new software. It took me 15 minutes to figure out why the new settingsite weren't working.

I managed to work? PV8 in northern Brazil last night around 2200 local time with my end fed half wave, so all is well.

73
Brent