hi all, ?just started to assemble the bitx40. ?new to kit building....confused on the e DC power connection instructions.
i route the two-wire connector from the PWR1 on the board to the power supply socket (brown wire to positive and black wire to grd).
now here where i am confused: ?am i supposed to run a wire from the power supply socket (positive connector where I just connected the brown wire of the two wire connector) to the Volume control (which connector on the volume control? ?would it be where the red wire is connected to the Volume control?)
next: ?it says to run a PA power line to the Power Amplifier. ?i don't understand from where to where I am suppose to connect this line.?
in the picture in the instructions it shows a brown and black wire from the two ?wire connector to the power supply socket. ?i get that. ?but then in the picture it shows a red wire attached to the power supply socket (positive) and a second black wire on the power supply socket (grd). ?but it does not show where this red wire goes nor where the second black wire goes?
sorry for the 'beginner' questions.
thanks for any help,
Paul
