Sounds like a hosed nano. I'm assuming you have the CH340 driver installed in your computer?
Vince.
toggle quoted message
Show quoted text
On 07/14/2017 06:42 PM, Curt M. wrote:
I have 12v in and 5v out like I would expect to have. I pulled the board
off of the display and connected it to my laptop. The radrino shows up
as USB-Serial CH340 (COM10) when I plug it into my laptop. The short
version of the error that I get while trying to upload is "programmer is
not responding", "attempt 1 of 10: not in sync"
i see the RX light flash occasionally while it trying to upload but it's
not taking the upload.
I've tried to press the reset button on the board and that didn't seem
to make a difference.
Board type in software is set for Arduino Nano
--
Michigan VHF Corp.
