开云体育

Winner winner chicken dinner, ptt isn't hooked up but was getting signal
feedback that seemed to be causing the problem. a little code fix and
boom
now i can use the new code with the multi-functions. Thanks for pushing
me in the right direction.

On Thu, Apr 27, 2017 at 10:09 AM, Allard PE1NWL <pe1nwl@...> wrote:

Steve,

It's hard to understand the issue without knowing what addtional code
you
are actually using, or what exactly you 'comment out', but my guess is
that any of your additional mods use pin A2 for PTT.
Is your pin A2 in some way connected to your PTT?

In the standard raduino code pin A2 is already reserved for the
CAL-button.
If you connect A2 to your PTT then this will interfere, because if pin
A2
goes to LOW, the calibration procedure will be executed.

The standard arduino code uses pin A6 for PTT, not pin A2.

73 Allard PE1NWL


On Thu, April 27, 2017 12:23, Steve Greer wrote:

I'm modded out with s meter forward and reverse power measuring. I

have
1

button and 1 switch. tried unhooking the switch all together but

still

happens may have to try shielded wires for the control lines.

Twisting

may
not be working. I run a single end of a ground wrapped around wires

for

shielding. calibrate is my only prob doesn't interfere with any other
functions beside calibrate. I've tried different LIBs and still an

issue.

Started unhooking thinks yesterday and couldn't find the root. So I

only

load code to calibrate when I need to and load the commented out code
after
I calibrate. Just extra work.

On Thu, Apr 27, 2017 at 3:50 AM, Allard PE1NWL <pe1nwl@...>

wrote:

Steve,

Just to understand your situation better, what is exactly your setup?

Standard unmodified BITX40 board with raduino_v1.07 (or 1.08) with

the

standard PTT switch? No other pushbuttons wired up except the FB
connected
to pin A3?

Or did you add any addtional modifications, buttons etc?

73, Allard PE1NWL