Re: Issues With calibrate and TX
|
Use a stiff 12V supply to start.? I have not had good success with anything less than 2A.? Linear if you have it. My BitX40/v1.07 works FB.
Larry KB3CUF
On Wed, Apr 26, 2017 at 1:19 PM, Steve Greer <km4ous@...> wrote: Ok it seems strange to me but whenever I have the cal function in my code when I hit ptt to TX it goes to calibrate and then save.? I have all wires with a ground wrapped around connected from 1 end shielding all wires and twisted.? I have no other buttons going wacky just the cal function.? It even happens with the new code that came out with the multi function button.? Goes straight to calibrate and then save and knocks everything out of whack.? Anyone have this issue and any resolution? thx 73 steve
|
