Re: Birdie at 7199 - a surprising observation!

Allard PE1NWL All Messages By This Member #24851 Hi Kevin, the default drive current is 2mA. So uncommenting the line and compiling with 2mA shouldn't make any difference. So then I guess it must have been the RG-174 coax (and the cable arrangement perhaps) that made the difference. Well, apparently 2mA works OK in your rig. You could still try 4, 6, 8 mA and see if it makes any difference (birdies, receiver sensitivity, noise, etc). 73, Allard PE1NWL toggle quoted message Show quoted text On Mon, April 10, 2017 15:37, Petry, Kevin wrote: Just a suggestion: I found that the drive current line in my Raduino was commented out. I removed the comment slashes and compiled with the current set a 2 MA. I also replaced the two wires that carry the VFO signal from the Raduino to the board with a short length of RG-174U coax and the birdie is now completely gone. Not sure which change killed it at this point. Kevin

Join [email protected] to automatically receive all group messages.

开云体育