I knew it was writing to eeprom but there is no matching call in the code to read it back. Either to apply it or pass it.? Neither does the library call it.? It can't possibly, how would it know which address it was ?? It's being assigned to a int32 but isn't called.
In the notes it is mentioned that the calibration value in eeprom be called in setup but it isn't.? It also mentioned that eeprom was used for the dual vfo's, that's not either.
I don't understand how others get it to work.? I can't unless I alter the code.
Perhaps Farhan can comment ?
--
Rob G4NQX
