开云体育

I get your point., Jerry.

?I fear whether the fet did not give up by a possible leakage between drain and gate.

?It is also possible at the solder side by any bridge .

?Secondly I also fear whether the Tx/Rx relay contacts got bunched !! getting interested in joining for proper diagnosis.

?Let us see.

regards

?sarma

?vu3zmv

On Wed, Feb 15, 2017 at 9:12 PM, Ion Petroianu <ion.petroianu@...> wrote:

When PA Pwr is applied the components that will create a short circuit between V+ and GND are:

C153, C154, C157 and Q15.

As Q15 gets hot I would say is toasted. I would try to remove it and apply PA Pwr again. If your receive signal does not change you found the fault.

Good luck,

--
Ion

VA3NOI

--

Regards
Sarma
?