开云体育

Hello Gents.

Thanks for the replies.

I'll attach the sketch, here are the pin-outs as physically attached:

Arduino pins:?

D2 - R encoder

D3 - R encoder

D4 - not connected (NC)

D5 - LCD RS

D6 - LCD E

D7 - LCD D4

D8 - LCD D5

D9 - LCD D6

D10 - LCD D7

D11 - R encoder button

D12 - NC

A4 - Si5351 SDA

A5 - Si5351 SCL

73 de KB1VNA

On Sat, Feb 4, 2017 at 11:09 AM, M Garza <mgarza896@...> wrote:

And I should learn to read....

I would attach the sketch you are using, since it has been modified for your needs.

Marco - KG5PRT?

On Feb 4, 2017 10:07 AM, "M Garza" <mgarza896@...> wrote:

Hello Eric,

I would recommend at least a link to the sketch.? You could also include it as an attachment.

Marco - KG5PRT?

On Feb 4, 2017 9:26 AM, "Eric Torraca" <eric.torraca@...> wrote:

Good morning all,

I'm having a problem with an Si5351/Arduino nano kit that I'm hoping to add to my pre-Raduino BITX40. I'm using the code site.?

The trouble is that the LCD only refreshes with the current frequency when the button is pressed to change the frequency step. Once I do that everything updates, but you can turn the encoder all day long and nothing will change on the LCD until you push the button to change the step. I've looked over the sketch and am just not seeing the problem. Can anyone else see where I'm going wrong? I'm using AK2B's sketch as-is with only the pins changed to match my setup. (Let me know if I should post the sketch. I wasn't sure what the etiquette was in this case.)

Any advice would be greatly appreciated!

73 de KB1VNA

Eric