开云体育

You can use the snap off connectors.

Snap off as much as you require, solder the wires and slip a piece of sleeve over the connections.

Lawrence

On Thu, Feb 2, 2017 at 7:38 AM, Thomas Noel <tnoel@...> wrote:

HA HA!? I started this thread and just today noticed the typo in the Subject: line.

I just want you to know my board is quite happy, as am I. That is meant to say Bitx40 SMD board.

Thomas W Noel

KF7RSF

On Feb 1, 2017, at 4:05 PM, Steve Robertson <bobs_otr@...> wrote:

In a pinch you can solder them, then I didn't crimp the wings that normally crimp on the wire, they aren't that tall so they'll fit in the housing and if it's a good solder joint there's no reason to crimp them.? Then you can use needle nose to crimp the upper one that grabs on to the wire jacket.? I found it helped to clip a little of those upper wings off.? The crimpers are faster, but soldering works in a pinch for just a few wires.