... you'll see the PTT and the 'main' relay - Pins 1 and 3 are RX+12V and TX+12V, respectively.

They're even LABELLED on the schematic as RX and TX! They're not labelled on the PCB, but you

can even test this with a voltmeter. Pin 1 will be +12 during receive. PTT and it will drop and TX (Pin 3)

will pop up to +12.

?

Pick off your 'GREEN' and 'RED' anodes. Most Bicolor LEDs I've seen have a common cathode,

so that (center) wire is ground.?
You can pick up GROUND from this same relay - Pin 16 of the relay is ground.?

??
An even better picture can be seen from the 'wireup' page: ?

?

The PTT Relay is right in front (and down a bit) from the PTT connector. PIN 1 is 'down' & 'right' (if you're

looking at the wireup.html page).

There's no need to desolder or remove the relay. Just go underneath and, strip your wires SHORT.
You just need like 3 or 4 mm. Just solder to where the relay socket pins are soldered (remember they're
'reversed' on the bottom) - Pin 1 - RX, Pin 2 - TX, Pin 16 (which is opposite from Pin1 - it's a 16-pin

socket) Pin 16 is ground. You can either run it to a connector and 'crazy glue' or hot-glue to the PCB

just underneath (and to the right of) the power connector - or, you can just run them in the free-air, maybe

use some shrink tubing to keep them together. Just run them to your Bicolor LED.

Hope that helps.?
Now - if I have some time this weekend, I'll snap some photos.

?

Mike Y