开云体育

?

I have no conductivity between the outside pins and middle ones. when the button is pushed. When release I do have conductivity between the center pins and inner pins. I hear the relay clicking. ?

Looks like the relay contacts went bad??

I order a replacement relay.?

On Jan 1, 2017, at 12:33 PM, Ashhar Farhan farhanbox@... [BITX20] <BITX20@...> wrote:

?

disconnect the PA power line. Push the PTT and check if the transmit relay is switching. measure the connectivity with a VOM. copy?

- f

On Sun, Jan 1, 2017 at 8:04 PM, Bill Kittilson bill@... [BITX20] <BITX20@...> wrote:

?

I can hear the bitx on a near by receiver.? The coils look fine. The 510 gets hot on transmit.? I hear the relay but it don't sound quite right. I order the replacement relays. I hope it's the simple.? Thanks. I'll update you when i get the replacement. ?

Thanks.?

On Jan 1, 2017, at 1:56 AM, Raj vu2zap@... [BITX20] <BITX20@...> wrote:

?

Bill,

Check L6 and L7 and see if it is making contact with the solder on the board.

Check the relay K2, I seriously suspect that it could be faulty. Take the output from K2 pin 16 and ground to a (bnc) connector and check the TX out there with a power meter. If there is normal output then relay is suspect.. or not operating. When you
press PTT the relay should click, you should feel that with your finger. I have seen a lot of similar relays fail in my service
experience.

Cood luck and Happy new year!
Raj vu2zap

At 31/12/2016, Bill Kittilson bill@... [BITX20] wrote:
>
>
>I managed to kill my bitx40. It was working great until I decided to tune up the big rig. I can still receive. No power at all on transmit. I replace the 510 transistor. Sill no output. The current does jump up to over 1 amp when I switch to transmit.
>
>Any idea what to look at next?