Re: Does anyone have a solution to wsjtx not transmitting on zbitx?
|
I suspect your powersupply is shutting down. 3.4 watt on sbit is fine for ft8
However, if you try to drive with the same tx level when in digi mode , your sbitx will now put out much much higher audio, causing zbitx to max out and possibly shutting down the pwr.
It does this in both sbitx and zbitx.
TRY: lower your tx drive on your zbit to 2 See if you get a reboot
Joe VE1BWV?
On Thu, Apr 10, 2025, 11:09?a.m. Leo Aniol, AI5II via <leomaniolone= [email protected]> wrote: If I turn TUNE on in the zbitx panel while in digi mode, the zbitx outputs 3.4W. If I click on Tune in wsjt-x the zbitx reboots
Leo, AI5II
I would put a new image on a new microsd v2 A1 . Sandisk extreme or equivalent.? Just to be sure the card is not the issue. Also when using Digi mode , the tx pwr out audio will drive yor zbitx to the max unless you turn your tx drive on sbitx way down. If you don't its possible your drawing to much current from the powersupply? ?which would shutdown your zbitx. It happenned to me .. and my current regulator on my powersupply automatically reduced my current causing a reboot.
Also do you only have issues on digital mode tx? What happens if you switch to am , key down tx And see if you get a good output.?
Joe VE1BWV?
On Wed, Apr 9, 2025, 11:50?p.m. Leo Aniol, AI5II via <leomaniolone= [email protected]> wrote: I downloaded a new image.
No update/upgrade
CAT changes frequencies with wsjtx?
Doing a check CAT does nothing?
Clicking Tune in wsjtx causes my zbitx to reboot
?
Leo, AI5II
?
?
|
