Re: Does anyone have a solution to wsjtx not transmitting on zbitx?
|
Doesn't work for me. ?Did firmware upgrade and went back to the installed pi image and with no updates to raspian I get the same results. No transmit.
Hamlib error: Communication timeout. If I hold down the tune button, the zbitx restarts.
Leo, AI5II
I have WSJT-X working fine. Software zbitx 106
ZBITXSelect? Digi mode on Zbitx
Turn ZBITX TX RF down,? as the audio TX drive is very high
**WSJT-X: Does updates for Rig Control Regarding Frequency Changes and Receiving**
WSJT-X? Settings: Network Hamlib 127.0.0.1 Cat Data -rear -( not microphone /? front)
Split none
You might also lower the PWR slide bar on WSJT-X.?
Joe VE1BWV?
On Tue, Apr 8, 2025, 2:37?p.m. Leo Aniol, AI5II via <leomaniolone= [email protected]> wrote: I've tried all the suggestions and setting from various emails on how to get wsjtx to transmit on my zbitx.
None of them work for me. Receive works just fine but when I do the "check cat" button nothing happens when I hit tune wsjtx goes thru the transmit motions. Same is true if I hit "auto cq". Wsjtx acts like it is transmitting but is not actually putting the zbitx into transmit.
I am getting hamlib protocol errors.
CAT is kinda working as I can change bands.
I am also seeing rigctl timeout errors if I use rigctl to connect to the zbitx.
Is it just? me or does anyone else have these issues.
FYI, I browsed the hamlib.c file and there is a comment in there about it being receive only.
Much help? is needed here.
?
Leo, AI5II
?
?
|
