Hi,
I have massive problem with my uBITX v5 for Calibrating.
When I set the Calibration:
eg +10 for the accurate 700 Hz on 14996.000 in USB
then press the Mic Button - says calib set.
goes back to receive - seems ok.
But if I turn the RIG off and on again - the frequency is much lower:
eg bay pressing Button 14996.000 - after boot 14664.650
It look like the value is not really set, only temporary in RAM.
I had this problems since I have this RIG.
Also the Rig is really deaf.. only the most strong stations are received
TX - I must on a given QRG go up for abt 300 Hz then is on the QRG for transmitting to the partners QRG
I spent hours for resolving this - but no result....
Is there not a point ( Tp on the PCB ) where I can set the Calibration ?
Have an Frequency counter/generator here, also other RIGS with are 100% accurancy.
--
**
73 de
HB9FIH Erich
HB9FIH