same size sink fin area??? with 1/2 flanges on both sides///
?but offset about 1/2 inch ..
perhaps? i just swap heatsinks ???
that was stupid on my part to not have thought of that before the nibbler started work!
toggle quoted message
Show quoted text
On 9/24/2024 4:19 PM, Joel Caulkins/N6ALT wrote:
Bill,
I'm not sure whats going on. I noticed you have SN 0045, mine was a V2 radio also, SN 0042 so built at the same time yours was and my new V3 board just dropped in very easy. Maybe the heat ink is slightly bigger, IDK. Maybe someone from HFSignals can give some help here. A picture might help also.
Joel
N6ALT
--
link to my QRZ listing
