William,
I'm not sure what you are talking about here. I'm mentioning about the
20Watt amp that I have and uBITx board I built and I am/was looking
for advice on the predriver stages. This is not a kit and is my
bespoke build.
Maybe you are on the wrong thread?
Have a lovely day and good weekend.
Best 73,
Ravi/M0RVI
On Fri, 13 Sept 2024 at 13:53, K9HZ via groups.io
<bill@...> wrote:
The learning for me was that I should never announce a product/ kit before I have them in hand and sell out what I have, re-stock and repeat. No more lists. I used the list to gauge part purchases in advance to negotiate the absolute best prices for the kits. The kits, as always, were sold at my cost so the savings by planning went to the buyers.
You know what they say. Learn. Never again.
Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ
Owner - Operator
Big Signal Ranch – K9ZC
Staunton, Illinois
Owner – Operator
Villa Grand Piton – J68HZ
Soufriere, St. Lucia W.I.
Rent it: www.VillaGrandPiton.com
Moderator: North American QRO Group at Groups.IO.
Moderator: Amateur Radio Builders Group at Groups.IO.
email: bill@...
From: [email protected] <[email protected]> On Behalf Of Bill Maxwell via groups.io
Sent: Thursday, September 12, 2024 6:04 PM
To: [email protected]
Subject: Re: [BITX20] Renewed attempt to hack together a workable PA
I suspect the nub of Andy's problem was the list of potential buyers that was run for many months before you understandably decided it was too much effort for too little gain to chase up the people on the list once you had stock available and opened purchase to all comers. I think quite a few on the list thought the list was still active and that you would get to them in time, so didn't respond to your "all comers" invitation, hence didn't actually lodge orders with you. I know I nearly fell into that category.
Bill, VK7MX
--
I'm here to add more value to the world than I'm using up.
