If you have the original probes then your readings will be
accurate. Otherwise you will need to to calibrate.
I have face this by mixing my various probes.
Raj
On 24/05/2024 5:25 PM, Carlo Piga via
groups.io wrote:
toggle quoted message
Show quoted text
Hi Farhan, I used CW to make measurements. I used
an old CRT oscilloscope with 100MHz bandwidth. The waveform was
well defined on the scope (3÷4 cycle inside the screen). The
bandwidth of the attenuator was 10MHz and I make measurements at
7 MHz.
Thanks for the reply.
Carlo,
Which mode are?you using? It is best to
measure this in CW. You must also check the scope's
bandwidth setting and the time base.
Thanks Evan.
I just update to the latest version. Nothing?
changing...
I will try with a ham wattmeter (that I must buy and
cost the same of the sbitx)...
Bye
Carlo IS0HLX
Il 24 Maggio 2024 12:25:28 CEST, Evan
Hand <
elhandjr@...>
ha scritto:
Carlo,
The last thing to try would be to update the
software.? I do not have any other suggestions, as
this is a new first-time power-up.
Maybe Ashhar Farhan or one of the other experts in
the group has other ideas.
73
Evan
AC9TU
Raj vu2zap