Me, but of course I designed it. ;-)
the only issue that I know of is that there is a slot cut out for the potential meter board for the ribbon cable. The problem is if you use that slot, you will install your potential meter upside down with the tuning knob on top.?
the other issue is that the build volume for that case is very large and will not be printable with the popular ender 3 printers. ?
73
Mark
--
AJ6CU/7
KD8CEC 2.0, Nextion Screens,? and open source uBITX Raduino boards for Arduino IOT, BLE, RP2040, Teensy 4.0, and Raspberry Pi Pico
https://github.com/aj6cu
