Re: sBitx no receive unless I restart the application

Ashhar Farhan · 2024-02-10T19:57:00-08:00

Dave, You might eliminate receiver issue by upgrading to v3 software. We will have to separately handle the low power. How low is low? - f

Ashhar Farhan All Messages By This Member #108900 Dave, You might eliminate receiver issue by upgrading to v3 software. We will have to separately handle the low power. How low is low? - f toggle quoted message Show quoted text On Fri, Feb 9, 2024, 11:08 PM d p via <dave.g4ufs=[email protected]> wrote: After a PA failure and a possible mishap when probing voltages as I was replacing the finals, My Bitx V2 will no longer receive from cold. That is to say, when I turn it on and start the application, I get noise but that is all. The strange thing is that if I stop the application and then start it again (NOT restarting the Raspberry Pi) the system receives ok I really cant work out what is going on. Another fault is that having replaced the finals, the power is very low, about 25 Watts on CW at full drive.? Any help gratefully received 73 Dave - G4UFS

Join [email protected] to automatically receive all group messages.

开云体育