On Thu, Jun 1, 2023, at 08:08 AM, Steve Beckman wrote:
Evan - the DigiSpark board will run fine at 3.3 Volts, in which case you do not need level shifters. I do recommend changing the clock setting to 8 MHz though. Still plenty fast enough for I2C communications.
73; Steve, N3SB
Steve,
Can you point me to the documentation on how to set the clock speed?? It would also help to know how to bypass the 5 volt regulator on the board.
I call it a DigiSpark board, as that was the first board that I could get the sample program to run.? I had to change to the?
ATtiny85 (Micronucleus / DigiSpark) board to get the sketch from Ashhar Farhan to compile.
Here is a picture of the two ATTiny85 boards that I have.
73
Evan
AC9TU
