Some further information - with the SWR tx out of the circuit the oscillations continue.? When I remove the Tx/Rx switch the oscillations go away.
I get back tonight.? Ill have some simple tests cooked up to get to the bottom of this.?
Dr.?William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton - J68HZ Soufriere, St. Lucia W.I. Rent it:
email:??bill@... ? ? So, I am still tracking down the 20W amp oscillation, and making progress.? I have C24 in the amp, although it makes no difference to the oscillation in the high bands.? I also have the onboard attenuator in the PA.? Bypassing the BPF and the LPF made no difference to the oscillation.? Ferrites, RF chokes, and additional bypassing right on the center tap of the output transformer made no difference.
The oscillation goes away when I take the output of the LPF directly to the dummy load bypassing the SWR circuit and the Transmitt Receive Switch.? I wonder if I have something wired up wrong in the transformer or the switch.
Thanks again for all of your help.
dave Sounds like the inpuu connection to the PA is high impedance (like something is not connected on the boads in front of the PA).. ?you migjt take the BpF put of the circuit temporarily.? Just jumper across it on the LPF board pr remove ?the LPF too just temporarily. ?
Dr.?William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton - J68HZ Soufriere, St. Lucia W.I. Rent it:
email:??bill@... ? ?Thanks Jerry and Bill. I¡¯ll get back to this on Monday. 3 dB pad on input of PA reduces oscillation, 6 dB pad stops the oscillation? dave ?Remove the bpf and see what happens. ?
Dr.?William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton - J68HZ Soufriere, St. Lucia W.I. Rent it:
email:??bill@... ? ?Yes, I agree. The amp is solid. Previously , I swept the amps and got solid performance. And, when I disconnect the drive to the amp the oscillation stops. It is being caused by something in the T41 interacting with the amp dave ?Something is wrong.? The amp will NOT oscillate by itself. ??
Dr.?William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton - J68HZ Soufriere, St. Lucia W.I. Rent it:
email:??bill@... ?
|
