¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

FW: [FlexRadioSmartSDR] Adaptive Predistortion Progress


 

¿ªÔÆÌåÓý

More mumbling about APP¡­ operating the amp at less than 25% of its average available output gives better IMD.? DUH.

?

?

Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ

?

Owner - Operator

Big Signal Ranch ¨C K9ZC

Staunton, Illinois

?

Owner ¨C Operator

Villa Grand Piton ¨C J68HZ

Soufriere, St. Lucia W.I.

Rent it:

?

Moderator: North American QRO Group at Groups.IO.

Moderator: Amateur Radio Builders Group at Groups.IO.

?

email:? bill@...

?

?

From: [email protected] <[email protected]> On Behalf Of WA1MBA via groups.io
Sent: Friday, February 14, 2025 9:56 AM
To: [email protected]
Subject: Re: [FlexRadioSmartSDR] Adaptive Predistortion Progress

?

In my recent talks about IMD, through observations of many amplifiers, most of which were Class A units, I came to the conclusion that runnunig 6 dB below the P1dB compression point kept the 3rd order product below 30 dB. Often much lower. Just a rule of thumb.

?

?There is at least one mfgr of amplifiers that rates them at 3kW (max, whatever that means) and gives good IMD performance at 1kW. Many hams solid state amplifiers are run at or close to their P1dB point on voice peaks.?

?

?Care has to be taken at all stages of analog design because every amplifier and mixer throughout a transceiver produces IMD. I believe that most modern radios are pretty clean up to the final amplifier where cost often dictates non-linear choices. All that said, producing -50 dBc or better IMD products before the power amplification requires detailed engineering of analog circuits. This low level is easily obtained and exceeded in a good SDRs of 14 or 16 bits RF sampling. Most readers of this already know that SDRs are good radios for many reasons. Clean signals is one.?

?

?The low level (0 dBm) 3rd order IMD output from my 6700 at 28 MHz was below -80 dBc. I say below because my two tone audio source measured about that level of IMD.?

?

On Fri, Feb 14, 2025, 10:22?AM Dave via <WB1S=[email protected]> wrote:

I'm not suggesting that we all run 6db down. Military applications often require better IMD performance due to Co-Site issues. Examples: shipboard operations (especially the big decks) may have many HF stations running with antennas close together. I'm just pointing out that observing signals on the Pan could be deceiving because of varying power levels.

?

Dave

WB1S?

Join [email protected] to automatically receive all group messages.