Re: Conductive Paint
¿ªÔÆÌåÓýI¡¯ll answer #2¡ the SPI can run at speeds up to 10 MHz¡ so anything in the 0.5-10 MHz region is concerning. ? ? Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton ¨C J68HZ Soufriere, St. Lucia W.I. Rent it: ? Moderator: North American QRO Group at Groups.IO. Moderator: Amateur Radio Builders Group at Groups.IO. ? email:? bill@... ? ? From: [email protected] <[email protected]> On Behalf Of chris corcoran via groups.io
Sent: Saturday, February 8, 2025 4:57 AM To: [email protected] Subject: Re: [AmateurRadioBuilders] Conductive Paint ? Both Conductive Paints look interesting. Two questions, if anyone has the energy to answer ?
? The MG Chemicals tech sheets imply that adhesion to Polypropylene is poor, not sure where PETG or PLA would fit. ? ? Silver paint (842AR) attenuation is so much better $$$$$$$ , even the Nickel based paint is much better. Not sure if the Carbon paint ?would just keep the elephants away¡ ?
?
From: [email protected] <[email protected]> On Behalf Of John ? Check this out, they are a trusted very well established comapany and the tech sheet makes interesting reading. Not sure about supply in the States, over here MG Chemical is very expensive. |
K9HZ