?

I found it. The 2-pin header is now J10 on the Main Board.
Still no transmit though :(. Wonder if the software thinks there's a
100W PA?

- Jerry

On 2024-12-22 10:14, Oliver KI3P via groups.io wrote:

The 20 W PA has such a 2-pin header, the LPF control board does not.
IIRC (don't have the schematic in front of me) it gets the TX/RX state
through the 10-pin IDC connector.

-------- Original Message --------
On 12/22/24 7:31 PM, jerry-KF6VB wrote:

So - now my V12/K9HZ system receives fine. Time to try to transmit.
So
I scrounged up an RG316 cable to connect the TX output of the RF
board
to the LPF control card. Hit the mike button, and ...nothing.

Then I remembered - there's a signal that went from the old V11 LPF
to
the PA, to tell it to transmit.
+12V on transmit. There was a 2-pin header. Does the K9HZ LPF
control
card have such a header? I'm not seeing it on the schematic.

- Jerry, KF6VB

Links:
------
[1] /g/AmateurRadioBuilders/message/5627
[2] /mt/110245804/243852
[3] /g/AmateurRadioBuilders/post
[4] /g/AmateurRadioBuilders/editsub/243852
[5]
/g/AmateurRadioBuilders/leave/11522011/243852/920863695/xyzzy