开云体育

Bill, I compared both: different selected display (cells 00 and 01) , no issue min power (cell 05) is now 5W, was 1W perhaps the reason for not to tune... (I hope) Ratio (turns on binocular) (cell

I tried it after downloading the original firmware that was in it.? But still doesn't work. Picture of original firmware. Picture of the version 3.2 I downloaded now. Thank you, Bill

ok, Bill, did you fill all cells of eeprom like before? with no values for minimal tuning power or number of windings on binocular there could/may be some unexpected reactions.. I ever set Vdd to 5V

1.? It was purchased as an assembled tuner.2.? Yes, it did work before.? I downloaded the original Firmware and saved it before updating it to the 3.2 version.? Even with the original software it

hi Bill, after beeing able to program the processor, there is a chance, that he will be able to do his work as intended. But ther are many reasons, why he is inhibited to do his work... :-) To enable

I have used my PICKIT 3 to program the PIC in my ATU-100.? I erased it first then after downloading Version 3.2 of the firmware I programmed it.? It passed Verify and the Blank Check.? I made the

I figured it out.? Thank you!! Doesn't work so I may have another problem.Bill

yes, that‘s it!

Is that the line 00?? Set 02 on that line to 01?Bill

hi Bill, look post #2277 for explanation of values ?at cells. For you: set cell 02 to 1 for automatic mode. 73, Immo

Is there a manual for version 3.2 of the firmware?? I want to change the code, so my tuner operates automatically for remote use. Bill

Figured it out as per this thread.? Update firmware to version 3.2 with Pickit 3.? Had to use 4.75 volts.? I am using MPLAB IPE Version 6.20 software with Windows 10.? Works

Found a header connector that I could use to connect the Pickit 3 to my ATU-100 but get an Invalid Device error message.? The 16F1938 was in the Pickit 3 drop down for ICs.? I connected the Pickit 3

I was not aware the first row color was an OLED hardware function. Will go ahead and reprogram the PIC unprotected. Thanks so much!

My ATU-100 never came with the cables because it was used as a remote with no display.? Where can I get the proper cables for it, and can the same cables be used to program it? Thanks, Bill

Thanks, Peter. Atu-10 algorithm is a brilliant!

I recently tested on a 450 Ohm metal oxide resistor I had on hand. This had some inductance but not too much. ATU-10 tuned it with no difficulty. [email protected]> wrote:

Hi John. Please see comments below. I hope this covers your questions. 73, Dave OLED DISPLAY The 0.96-inch OLED displays with 128 (columns) x 64 (rows) come in various (fixed) arrangements. ? ?

Have a 3.2 kit purchased from amazon. On boot it shows 3.2, and the power measurement is yellow, but youtubes of 3.2 show it as the same blue as the other values. Reading the unit with PicKit shows it

Hi Bob, sorry for delay. I had no issue building several ATU-10's, for parts.? The relays are expensive if bought from Digikey etc but there was an ebay vendor selling them cheap too. On my PCB I