开云体育

Hi, I am getting more confused now lol. I am talking about 0B and 0D *0B if the inductance line has a linear pitch 01 should be entered in the cell. The* *default value is 00.* And *0D if the

I think you misunderstood the manual. Linearity is a on/off switch. It disables a software formula that tries to overcome the lack of linearity of detection diodes. That should only be used if your

Sorry, but what to you mean by '2**x'?

I have the same issue. Worked for a couple of hours then the screen went blank.? It charges for about 10 minutes but nothing happens. K9EZ

Hi. Any 2**x row. Exact values are difinited in other cells .

What about the IN34A diode used in the LDG AT100 ProII? This one has even lower junction capacitance. 1pF @ 1mhz

There are 2 linearity settings for L and C. How do I interpret this? Linear is: 10pf, 20pf, 30pf, 40pf? Or 10pf, 20pf, 40pf, 80pf? How must I interpret this? 73 Bjorn de PD5DJ www.pd5dj.nl

It depends upon your operating frequency and what type of load you're trying to tune. It's probably not the answer you're looking for. Al, K2ZN

Can anyone tell me what is the max VSWR that the AT100 (3.2 firmware) can generally tune? Thanks

I have performed a "calibration" but I think it is harder then suggested. There are some factors playing in the ATU-1000 Situation. 1. When setting eeprom address 30 to 01, to activate highpower

Kaz You must be using an early version of the firmware, the internal reference is set in version 3.2 with: ADCON1.B0 = 1;? ?// ADC with the internal reference ADCON1.B1 = 1;

Hi, The ATU-100's power measurement issues have been resolved and are now tuned correctly. There was a problem on line 63 of pic_init.c. ADCON1 = 0xA0; This will supply the ADC reference

It sounds like you've done your homework about the differences in the devices! There's an open source program to control the minipro boxes. You can probably add the changes you've discovered for the

Yes, I was hoping that would be possible. Unfortunately it seems there is only a DLL file that contains all chips information. I've had a peek into it by disassembling it, and the infoIC2Plus.dll

I'd like to obtain an ATU-10.? Preferably a kit option. I'd appreciate a pointer to either a group by / kit option or?to a known good vendor of a built ATU-10. 72 de Bryan, k0emt

Thanks, I figured this should be the way. Will have a go today :-)

Ok thanks TonySent from my Samsung Galaxy S7 smartphone.

Get a wattmeter and dummy load. Feed power thru the tuner in the FWD direction and set the pot to give you the same power the wattmeter says it is. Now switch the in and out of the tuner and do

I went through all the bands to document it against my 80M EFHW prior to attempting to repair it. 1850 - 3.71:1 3550 - 1.22:1 5405 - 1.75:1 7050 - 1.93:1 10110 - 1.95:1 14.050 - 2.82:1 18080 -

I'm also having tune problems with my ATU-10. I found a few workmanship issues, the main ones being excess solder on several of the shunt capacitors and tiny balls of solder lodged between a few of