开云体育

Hi Thanks to you all for your input on this problem, I think the general consensus is the voltages arriving at the PIC inputs from the bridge are too low for some reason. I'll rebuild the bridge

John He quotes 1v out of the SWR diode detector but nothing at the PIC. glenn

Steve If you trace through the schematic you will see the forward and reverse voltages from the SWR diodes are fed to the PIC via a voltage divider using 68k and 34k resistors..

Auto tuning with 50w should not be a problem. It should work and it should read something close to the 50. Regardless of whether this is a PIC that has a 4 or 5 volt reference. I think these devices

Steve, Try tuning it with 5W. If it works then you need to reduce the number of turns on the sense transformer from 10 to 5 and change the settings in the eprom (needs a pic programmer) so that it

I'm not sure which pic controller is placed on the system but depending type the maximum input is between 4 and 5 volt for full power. Looks to me something not correct with the bridge or components

Hi Ive just been given a faulty ATU 100 EXT (brand new ready built unit). The display remained dark on powering up, I happened to have a spare display so replaced it which resulted in a nice bright

I think it can be explained by loss in the inductors? If the cores are low Q than the measurements will reflect that. Best regards Onno Op za 27 nov. 2021 23:48 schreef john_mellars via groups.io

Hi. That is a simple Icom tuner interface, you can find a lot of info in internet.

Hi I built up an ATU-100. In general it seems to work. To learn more about it, I put a 50 ohm termination on the RF out port and put my NanoVNA on the RF Input and put the atu in test mode. I also

Curious, what exactly is the Ext port on the ATU-10 do. The github README does not describe it and on VK3PE schematic i can see the connections to RD1 and RD2 but that does not tell me anything. Any

Hi Guys, Maybe someone will help me .... How to calculate the value that should be entered into Eeprom - cell # 31. I want to measure the power up to 1000W and I have 20 turns wound in the coupler

Josep The 3.5mm 'stereo' socket is designed to connect to an ICOM IC-705. It's a 1 to 1 connection, ie tip to tip, sleeve to sleeve and ground to ground. So, just make up a cable at length you need.?

You saw the second one, it is the first one you did not took care about .... 73 Patrice.

Ok Firmware: ATU-1000W 3.2 -oled-0.96inch-display.hex I did not see the second one... Regards , Marek SQ7BCN 73 W dniu 2021-11-26 o?20:30, F1RVC pisze:

I sent 2 firmware so I did not know which one you talked about...

Hi, I don't think you understood I asked about the firmware you sent: ATU-1000W 3.2 -oled-0.96inch-display.hex In this firmware,? Eeprom in cell #31 is value 99 Cell # 31 is the gear of the coupler

Hi David. I have ATU-10 with some bad lectures. Have you schematic how you connect the ext port ?? Thn?ks Josep

Twist wires is also ok sometimes..

20 turns is ok. what is your firmware used for it? I do not have same value in #31 depending on the firmware you are using.